M60 Motor Driver Interface Board

The M60 is a Stepper Motor Driver Interface and Power Supply board that allows a complete system to be built in one stack. Typically the M60 is mounted over the M41K board and connected with a ribbon cable. Motor drivers are then snapped into the M60 to complete the system. Due to the way that the system is set up, you can intermix 40V and 70V drivers without making changes to the system. The correct voltage is automatically routed to each driver.

Also check out our various motor driver solutions including the MMD-05, MMD-02 and MMD-03. These drivers snap right onto the M60 board, which provides power for the drivers. Technical details can be found on our wiring page for the M60.